![]() ![]() Thread the eye bolt into the load until the shoulder is flush and securely tightened against the load.Drill and tap the load to the correct sizes to a minimum depth of one-half the eye bolt size beyond the shank length of the machinery eye bolt.After the loads on the eye bolts have been calculated, select the proper size eye bolt for the job.įor angular lifts, adjust Work Load Limit as follows:.Machinery Eye Bolts are primarily intended to MACHINERY EYE BOLT- INSTALLATIONS FOR IN-LINE AND ANGULAR LOADING. When using lifting slings of two or more legs, make sure the loads in the legs are calculated using the angle from the vertical to the leg and properly size the shoulder nut or machinery eye bolt for the angular load.Never exceed the Work Load Limit of the eye bolt, see Tables I & 2.Always apply load to eye bolt in the plane of the eye,.Always lift load with steady, even pull – do not jerk.Regular Nut and Shoulder Nut Eye Bolt-Installation for In-Line Loading. Read, understand and follow information in diagrams and charts below before using eye bolt assemblies.Read and understand these instructions and follow all eye bolt safety information presented here.A falling load may cause serious injury or death.Loads may slip or fall if proper eye bolt assembly and lifting procedures are not used.Always tighten nuts securely against the load.Always screw eye bolt down completely for proper seating.Always countersink receiving hole or use washer with sufficient I.D.Never undercut eye bolt to seat shoulder against.For angular lifts, adjust Work Load as follows:.Always use shoulder nut eye bolts (or machinery eye bolts) for angular lifts.Never use regular nut eye bolts for angular lifts.Never exceed Work Load Limits specified in Tables 1 & 2.Always be sure threads on shank and receiving holes.Never use eye bolt if eye or shank is bent or elongated.Never use eye bolt that shows signs of wear or damage.IMPORTANT INFORMATION: READ, UNDERSTAND AND FOLLOW. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |